Stand Plunger Attachment (1/2 Inch Bolt)

This accessory is important for DIY wedding receptions that need control over how their specialty lighting effects looks. To attach the light you unscrew the top nut, slide the lighting bracket on the screw, and screw the 1/2 inch nut back on. This sandwiches the bracket in-between the two nuts.

A couple of important considerations are to make sure you don’t screw on the top nut too tight. This might require you to use tools to detach (not provided). We do not recommend keep the plunger in an area that gets a lot of heat/sunlight, if left in hot conditions then the metal bolt might expand on the nut making it slightly harder to loosen the nut on the plunger.

The bottom nut never comes off, only the top nut is taken off and put back on. Make sure you don’t accidentally misplace the 2nd screw on-top. If you do, you can easily take this plunger to a hardware store, pay less than a dollar, & they can match up another nut to fit on-top. Rent light stand attachment today to use in your setups.