.
.
.
Watch QR Codes Make Setup EZ
Watch How Clients Save More
Watch How Vendors Make More
Watch How to Ship & Return
.
.
.
.
Setting up water effects lighting is super easy. Once plugged in & turned on, scroll to the color & stop the color wheel rotation. There are a total of (6) colors for you to choose from. Each color works better with different themes. It will look like you are dancing under the water when blue is used on your ceiling. Create realistic flames projected onto your wall with red. Add a light stand & adapter to your package to elevate the light for better control. Read More...
| Weight | 4.85 lbs |
|---|---|
| Dimensions | 10 x 9 x 8.5 in |
You must be logged in to post a review.
Turn off all venues room lights off or set to the lowest setting you are comfortable with. This helps give you the best results projecting the h20 water effect. You can aim your onto any flat neutral colored surface. Avoid aiming fixtures on brick, stone, wood, glass, mirrors, dark walls, and rooms with emergency lighting. Use the color that best matches with your theme. You can even stop the color wheel rotation in between (2) colors for a dual look. We highly recommend reserving a stand with light adapter to elevate this fixture. This gives you more flexibility with setup (aim on floor, aim higher, prevents guests from walking in beam casting shadow).
When your overhead venue lights are dimmed, lighting creates a beautiful glow for your reception photos. If your hall is a golf course with a lot of windows then this effect will be more noticeable immediately following your sunset. You can look up when the sunsets in your area by using this great tool Sunrise Sunset Calculator.
How to setup underwater effects lighting with h20 smoke light
With Stand and Plunger (helps elevate fixture to cover more space & control beams)
1.) Widen tripod stand by loosening the side knob and pulling the legs out to form a wider base.
2.) Once you have the legs pulled to the right width (approximately 2 feet), then you can re-tighten the bolt (don’t over tighten)
3.) Attach plunger by sliding over top of light stand (it should be a tight fit)
4.) To attach the light you unscrew the top nut, slide the lighting bracket on the screw, and screw the nut back on (sandwiches the bracket in-between the two nuts)
5.) Plug h20 smoke effect in with power cord between the fixture and outlet
6.) Turn power switch on (located in the back of unit)
7.) Adjust front focus to desired setting by rotating lens either clockwise or counter-clockwise
8.) Use 2nd switch in back of unit start and stop color rotation on desired color
7.) Elevate stand if necessary and aim your h20 water effect in the desired position (use the side bracket to adjust the angle)
Setup on Table (no stand or plunger)
1.) Plug h20 smoke effect in with power cord between the fixture and outlet
2.) Turn power switch on (located in the back of unit)
3.) Adjust front focus to desired setting by rotating lens either clockwise or counter-clockwise
4.) Use 2nd switch in back of unit start and stop color rotation on desired color
5.) Place fixture either on table or floor and aim your h20 water effect in the desired position (use the side bracket to adjust the angle)
Use our formula below to figure out the best number of h2o smoke effect(s) to reserve:
Maximum Coverage: (8) h20 effects (covers majority of large room)
Ideal Coverage: (4) h20 effects (covers 50% of large room or majority of small room)
Moderate Coverage: (2) h2o effects (covers 50% of small room)
Minimal Coverage: (1) h2o effect (covers small dance floor)
Elevate fixture by renting a light stand & plunger to project UV effect farther & control beam direction. Reserve extra extension cords if you are concerned about getting power to your black lights.
Red, Blue, Purple, Yellow, Green, White (see color examples in product images above)
Scan for Fast Access to this Product Page
Why is State N/A?
Reviews
There are no reviews yet.