Wedding Monogram Lighting (Rent Wall Projector)

Description

Additional information

Lighting Factors

Turn off all wall sconces & lower your banquet halls house lights for maximum exposure from name monogram. This fixture looks best when aimed almost directly straight onto a surface on the opposite side of the room. We highly recommend reserving a stand with plunger to elevate this light. This give you more flexibility with setup (aim on floor, aim higher, prevents guests from walking in beam casting shadow).

When your overhead venue lights are dimmed, lighting creates a beautiful glow for your reception photos. If your hall is a golf course with a lot of windows then this effect will be more noticeable immediately following your sunset. You can look up when the sunsets in your area by using this great tool Sunrise Sunset Calculator.

Easy Setup Instructions

How to setup wedding name monogram light rentals with custom gobo

Setup name monogram with optional stand/plunger (helps elevate fixture to cover more space & control beams)

1.) Widen the tripod stand by loosening the side knob and pulling the legs out to form a wider base.
2.) Once you have the legs pulled to the right width (approximately 2 feet), then you can re-tighten the bolt (don’t over-tighten)
3.) Attach the plunger by sliding it over top of the light stand (it should be a tight fit)
4.) To attach the light you unscrew the top nut, slide the lighting bracket on the screw, and screw the nut back on (sandwiches the bracket in-between the two nuts)
5.) Plug the wedding name monogram into with power cord between the fixture and outlet
6.) Fixture will automatically turn on, slide barn doors painted red from the side of the fixture outwards, this makes the beam shine through the barrel
7.) Elevate the stand if necessary and aim your name monogram in the desired position (use the side bracket to adjust the angle)
8.) Use the green nobs on the fixture to adjust the zoom and focus (might take a minute to get in the best position)

Setup on name monogram on the table (no stand or plunger)

1.) Plug the wedding name monogram into with power cord between the fixture and the outlet
2.) Fixture will automatically turn on, slide barn doors painted red from the side of the fixture outwards, this makes the beam shine through the barrel
3.) Place the fixture either on the floor table and aim your name monogram in the desired position (use the side bracket to adjust the angle/elevation)
4.) Use the green nobs on the fixture to adjust the zoom and focus (might take a minute to get in the best position)

Monogram Distance Chart

Upgrades

Elevate fixture by renting a light stand & plunger to project name farther with control beams. Reserve extra extension cords if you are concerned about getting power to your wedding name monogram.

Design Templates

Pick any of the 27 samples below. Please remember to triple check any information before adding this rental to your cart. We will need the following 3 pieces of information before completing your order:

1.) correct sample number
2.) correct name spelling
3.) correct date & format

QR Code

Scan for Fast Access to this Product Page